CHIEF PXR, Руководство по установке

Страница: 11 / 32

Installation Instructions PXR
11
8. Mark the pilot holes through PXR upper bracket. (See
Figure 7)
9. Carefully remove the PXR from the mounting bracket.
10. Drill two 7/32" x 2-3/4" (5.5mm x 69.9mm) pilot holes at
locations marked in Step 9.
11. Return PXR to mounting bracket and fasten to wall using
two 5/16 x 2-1/2" lag screws (RC) and two 5/16" flat
washers (RB). (See Figure 7)
Figure 7
12. Remove two orange Velcro® straps holding PXR arms in
place. (See Figure 8)
Figure 8
13. Connect and route power cord (Z) through PXR cable
management areas. (See Figure 9)
Figure 9
IMPORTANT ! : Do not power the PXR until it is ready to
be tested.
8
x 2
10
11
(RC) x 2
(RB) x 2
Strap locations 12
13
(Z)
NOTE:
Proceed to Arm Engagement section.