CHIEF PWRSKU, Руководство по установке

Страница: 6 / 12

PWRSKU Installation Instructions
6
Mount Installation And Adjustment
Mount Installation
After determining the site meets the installation requirements:
1.
Identify desired mounting location on wall.
2. Using a stud finder or similar method locate studs.
3. Align mounting holes in mount with studs making sure
mounting holes are centered on studs. (See Figure 2)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Make sure upper
and lower mounting holes are used on both sides of both the
upper and lower wall plates. (See Figure 2)
4. Mark location of eight mounting holes on wall.
5. Drill eight 1/2" (Ø13mm) holes. (See Figure 2)
Figure 2
6. Hold metal channel on anchor (D) flat alongside plastic
straps and slide channel through hole. (See Figure 3)
Figure 3
7. Holding plastic straps on anchor (D), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See Figure
4)
8. Slide plastic cap on anchor (D) towards wall until flange of
cap is flush with wall. (See Figure 4)
Figure 4
9. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 5)
10. Repeat steps 6 through 9 for each mounting hole.
Figure 5
11. Place mount over anchors and align mounting holes in
display mount with holes in anchors. (See Figure 6)
12. Place flat washer (B) onto Phillips pan head screws (C).
13. Insert Phillips pan head screws (C) with flat washer (B)
through mounting hole in display mount and into anchor (D)
and tighten until flush against mount. DO NOT overtighten!
(See Figure 6)
14. Repeat steps 6 through 13 for remaining 7 mounting holes.
1/2" (Ø13mm) x8
Mounting holes
centered on
studs
1
3
4
5
(D) x8
Drywall
Plastic Straps
6
Plastic Cap
Steel Stud
Drywall
Anchor Metal Channel
SIDE VIEW
(D) x8
8
Plastic Straps
Steel Stud
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
9