Installation Instructions
TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
13
Fastener Installation Methods
IMPORTANT ! :
See Table 1 for appropriate hardware
and pilot hole sizes for various wall types.
IMPORTANT ! :
The expanse of the LED wall will most
likely mean that attachment of the wall mounts will not all
be in studs. The attachment method will most likely vary
throughout the installation, and more than one of the
various methods outlined here will most likely be used.
Wood Stud
1.
Use one 5/16" x 2-1/2" hex flange head lag bolt (C) and one
5/16" washer (D) through product and into pilot hole. (See
Figure 19) and (See Figure 25)
2.
Repeat for remaining pilot holes.
Figure 19
Concrete or Concrete Block
1.
Install one UX10X60R anchor (B) into each pilot hole using
a hammer, making sure that the anchor is flush with the wall.
(See Figure 20)
2.
Use one 5/16" x 2-1/2" hex flange head lag bolt (C) and one
5/16" washer (D) through product into each anchor in wall.
(See Figure 20)
3.
Repeat for remaining pilot holes.
Figure 20
Steel Stud
IMPORTANT ! :
See
Site Requirements for Steel Stud
Installation
section before proceeding with Steel Studs
installation to ensure installation site meets requirements!
The drywall must have a minimum thickness of 1/2"!
1.
Hold metal channel on anchor flat alongside plastic straps
and slide channel through hole. (See Figure 21)
Figure 21
2.
Holding plastic straps on anchor, pull anchor away from wall
until channel rests flush behind wall making sure anchor
channel is positioned vertically on drywall, or steel stud (if
present). (See Figure 22)
3.
Slide plastic cap on anchor towards wall until flange of cap
is flush with wall. (See Figure 22)
Figure 22
4.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 23)
1
2
(C)
(D)
1
2
(C)
(B)
(D)
Drywall
Plastic straps
1
Plastic cap
Drywall
Anchor metal channel
3
Steel stud
(side view)
2
(if present)
