ODMLT
Installation Instructions
2
DISCLAIMER
Milestone AV Technologies, and its affiliated corporations and
subsidiaries (collectively, "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
DEFINITIONS
MOUNTING SYSTEM:
A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component
is attached.
ACCESSORY:
AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may
have a component attached or setting on it.
COMPONENT:
A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting
system such as a video camera, CPU, screen, display,
projector, etc.
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all mounting systems/
accessories are properly assembled and installed using the
instructions provided.
WARNING:
Failure to provide adequate structural strength
for this mounting system can result in serious personal injury
or damage to equipment! It is the installer’s responsibility to
make sure the structure to which this mounting system is
attached can support five times the combined weight of all
equipment. Reinforce the structure as required before
installing the mounting system.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components does not exceed 175 lbs (80 kg).
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
IMPORTANT ! :
The ODMLT mounts are designed to be
mounted to a 2" x 4" wood studs (16" or 24" on center) wall with
a maximum covering of 5/8" thick drywall, plywood, OSB,
fiberboard, buffalo board or other similar sheathing materials.
IMPORTANT ! :
The ODMLT mounts may be installed to a
bare 8" concrete wall if 5/16 x 3" Buildex® Tapcon® anchors
with Blue Climaseal® coating (not included) are used in place of
lag bolts (D) provided.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
29.00
736.6
2.00
50.8
2.00
50.8
1.50
38.1
4.00
101.6
6.00
152.4
1.31
33.3
6.01
152.7
.50
12.7
.63
15.9
MAX: 25.34 [643.8]
MIN: 5.03 [127.7]
18.00
457.2
8.00
203.2
6.75
171.5
.63
15.9
24.00
609.6
16.00
406.4
8.00
203.2
3.27
83.1
15 TILT
TOP VIEW
