Installation Instructions
MSP-WL4
7
Array Installation
1.
Slide rotational spacer (P) into opening on array attachment
bracket. (See Figure 4)
2.
Use 5/16-18 x 3" button head cap screw (G), two thin steel
washers (M), plastic washer (N), pocket washer (J), pivot
pin (H), pivot point spacer (R) and 5/16-18 lock nut (K) to
secure array (E) to arm assembly (A). (See Figure 4)
NOTE:
Cable clip (Q) can be used in place of pivot point spacer
(R) if additional cable management is desired. (See
Figure 4)
Figure 4
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the MSP-WL4 mount up to (and
including) the display does not exceed 15 lbs (6.8 kg) per
display and 30 lbs (13.6 kg) total. Use with products heavier
than the maximum weight indicated may result in collapse of
the mount and its accessories causing possible injury.
1.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 5)
Figure 5
2.
Carefully place display face down on protective surface.
3.
Connect faceplate to display
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x14mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 6)
Figure 6
(P)
1
(G)
2
(N)
(M) x 2
(J)
(E)
(H)
(K)
(A)
or
(R)
(Q)
quick release lever
1
1
(for flush mounting holes)
(B) x 4
quick release
faceplate
3
