CHIEF LDB1U, Руководство по установке

Страница: 6 / 12

LDB1U Installation Instructions
6
Assembly And Installation
Display Enclosure Assembly
1. Loosely install two 1/4-20 x 1/2" button head security
screws (W) into top holes on table stand (R). (See Figure 1)
2. Hang table stand interface (S) over two partially installed
screws. Use upper holes for higher installation or lower
holes for lower installation. (See Figure 1)
3. Use two 1/4-20 x 1/2" button head security screws (W) to
secure table stand interface (S) to table stand (R). (See
Figure 1)
4. Tighten all four screws.
Figure 1
5. Determine mounting location by setting table stand on desk
and experimenting with desired rotation capabilities.
NOTE:
Rotation radius can be set to be /- 15 or 30 .
See Dimensions graphic for details.
6. Use clamping plate (AA) as a template to mark locations for
the three holes to be drilled at desired mounting location.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! The mounting surface must be a
minimum of 3/4" in depth for medium-density fibreboard or
particle board. If mounting to another type of surface, make
sure surface can hold up to four times the combined weight of
all equipment prior to mounting the LDB1U to surface!
7. Drill three 5/16" holes at locations marked in Step 3. (See
Figure 2)
NOTE:
If cables are going to be routed through the table, an
additional hole needs to be drilled in center of clamping
plate (A). See Cable Management Section for details.
8. (Optional) If cables are going to be routed through the desk,
drill an additional hole in the center of the clamping plate
that is large enough to account for all cables that will be
routed through the desk. (See Figure 2)
NOTE:
One hole should be centered at the front of the mount.
Figure 2
9. Lift base cover up to expose mounting holes on table stand
(R). (See Figure 3)
10. Use three 1/4-20 x 2 1/2" tapping bolts (BB), three 1/4"
washers (CC) and clamping plate (AA) to secure table stand
(R) to table. (See Figure 3)
Figure 3
1 (W) x 2
(R)
(S)
2
(W) x 2
3
upper
holes
lower
holes
(lower installation shown)
x 3
front of mount
6
7 x 3
8
(AA)
9
(BB) x 3
10
(AA)
desk
(CC) x 3