CHIEF LDB1U, Руководство по установке

Страница: 7 / 12

Installation Instructions LDB1U
7
11. Use #10-24 x 1/2" security screw (V) to secure table stand
cover to table stand (R). (See Figure 4)
Figure 4
NOTE:
Prior to installing display, the rotation radius should be
adjusted. Once the display is connected, it will no
longer be possible to adjust the rotational stop without
removing the display from the mount.
12. Use the 5/32" security hex key (Z) to loosen rotational stop
adjustment screw until desired radius is achieved. (See
Figure 5)
WARNING:
TO REDUCE THE RISK OF BURNS, FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS, rotational
stop must be in place prior to display installation! If stop is not
in place, the cables may be damaged if the display is over-
rotated! Always make sure rotational stop is in place before
proceeding with installation!
Figure 5
Attaching Interface Brackets to Screen
1. Align the center of the bracket (T and U) with center of
screen. (See Figure 6)
NOTE:
The diamond-shape holes in the bracket correspond to
the center of the mount.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
2. Select correct screws, nesting spacers (if necessary) and
universal washers (if required) from the hardware bag (A-N)
and attach brackets to back of screen. (See Figure 6)
Figure 6
IMPORTANT ! : The M8 screws do NOT require a
washer. Use the universal washer (N) only with M4, M5
and M6 screws.
NOTE:
The nesting spacers (M) may be used separately, or
put two together in different configurations to create
different size spacers. (See Figure 7)
Figure 7
(V)
11
table stand cover
(view from beneath)
rotational stop
adjustment screw
15
30
rotation
radius's
Center of bracket
Pull cord
[Brackets T and U
(M)
(N)
(A-L)
NOTE: Use universal washer (N) ONLY with M4, M5
and M6 screws.
shown]
(Single) (Nested) (Stacked)
0.375
[9.5]
0.563
[14.3]
0.750
[19.1]