KRAMS
Installation Instructions
6
Assembly And Installation
IMPORTANT ! :
The KRAMS accessory is designed to
mount Chief’s K1W or K2W Series mounting systems to
a steel studs wall. Do not attempt to install any other
mounting system to this accessory.
1.
Hold adapter plate (A) up to the wall on top of steel stud at
desired mounting location. (See Figure 1)
2.
Mark three hole locations. (See Figure 1)
3.
Drill a 1/2" (12.7mm) hole at the desired mounting locations.
(See Figure 1)
Figure 1
4.
Hold metal channel on anchor (D) flat alongside plastic
straps and slide channel through hole. (See Figure 2)
Figure 2
5.
Holding plastic straps on anchor (D), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See Figure
3)
6.
Slide plastic cap on anchor (D) towards wall until flange of
cap is flush with wall. (See Figure 3)
Figure 3
7.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 4)
8.
Repeat Steps 3 through 7 for the other mounting hole.
Figure 4
9.
Place adapter plate (A) over anchors and align mounting
holes on mount with holes in anchors. (See Figure 5)
10. Use two 1/4-20 x 1 3/4" Phillips pan machine screws (B),
two screw caps (E) and two 1/4" washers (C) to secure
adapter plate to anchors (D) using top and bottom mounting
holes. (See Figure 5)
Figure 5
2
3
1/2" (12.7mm)
(A)
(D)
Drywall
Plastic Straps
4
(D)
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
5
Steel Stud
6
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
7
Steel Stud
(B) x 2
(D) x 2
(C) x 2
(A)
10
(E) x 2
