CHIEF K1S120, Руководство по установке

Страница: 10 / 20

K1W/K1S Series Installation Instructions
10
Assembly And Installation
Figure 1
(F) x 2
(E)
(G) x 2
3
4
5
set screw
6
side view
(A)
Connecting K1W Series (wall mount) to Wall
1. Determine mounting location on wall.
2. Use a stud finder to locate 2" x 4" wood stud.
3. Use wall bracket (E) to mark and drill two 1/8” x 2 1/2” holes
in wall at desired mounting location. (See Figure 1)
IMPORTANT ! : Only top and bottom holes of wall
bracket (E) must be used to attach bracket to wall as
shown in Figure 1. Do NOT use any other holes to secure
bracket to wall!
4. Use two 1/4-2 1/2” hex head lag screws (F) and two 1/4”
washers (G) to install wall bracket (E) onto wall. (See
Figure 1)
IMPORTANT ! : Over tightening screws (F) may cause
bracket to compress into soft wall surface resulting in
difficult mount installation or improper engaging of set
screw in Step 6.
5. Hang monitor arm (A) over wall bracket (E). (See Figure 1)
6. Secure monitor arm to wall bracket (E) by tightening set
screw. Ensure set screw engages back side of wall bracket
(E) to properly secure mount. (See Figure 1)
Connecting K1S Series to Office Furniture
NOTE:
K1S220 has an OFBU bracket instead of an OFBLU
bracket. Proceed to K1S220 section if installing
K1S220.
K1S120 and K1S22H
1. Determine mounting location.
2. Hang OFBLU bracket onto slat wall at desired mounting
location by inserting the upper mounting plate into wall
track. (See Figure 2)
3. Let lower mounting plate rest against slat wall.
Figure 2
3
2
OFBLU bracket
(arm not shown
for clarity)