CHIEF K1S100, Руководство по установке

Страница: 8 / 12

K1S100/200 Installation Instructions
8
Pivot Adjustment Range (K1S200 only)
1. Adjust arm angles as desired within a 90 degree range from
the wall and a perpendicular centerline of mount. (See
Figure 7)
Figure 7
Portrait Adjustment
1. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
8)
Figure 8
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! See
Display Removal section for details.
Cable Management
1. Use screwdriver to unhinge tab on either end of cable
management cover on upper arm. (See Figure 9)
2. Slide screwdriver along edge of cover until remaining tabs
are unhinged and cover is in the "open" position. (See
Figure 9) and (See Figure 10)
Figure 9
Figure 10
3. Route cables through cable management channel. (See
Figure 10)
IMPORTANT ! : Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4. Close cable management cover on upper monitor arm. (See
Figure 10)
5. Route cables through cable management clip on lower arm.
(See Figure 10)
perpendicular centerline
90 degrees range
of motion per arm
edge of desk or wall face
(top view)
(K1S100 shown)
cable management cover
1
2
2
4
3
cable (typical)
5
(K1S100 shown)