CHIEF K1S100, Руководство по установке

Страница: 6 / 12

K1S100/200 Installation Instructions
6
Figure 1
2
set screw 3
side view
2
set screw
3
K1S100 to OFBLU
K1S200 to OFBU
(E)
(G)
Assembly And Installation
Connecting K1S100-200 to Slat Wall
1. Install OFBLU (E) or OFBU bracket (G) to slat wall following
corresponding installation instructions.
2. Hang monitor arm (A) over OFBLU (E) or OFBU bracket (G).
(See Figure 1)
3. Secure monitor arm (A) to OFBLU (E) or OFBU bracket (G)
by tightening 1/8" set screw (J). Ensure set screw engages
back side of wall bracket to properly secure mount. (See
Figure 1)
Display Installation
1. Remove quick connect faceplate from mount by pressing
release tab and sliding faceplate off mount. (See Figure 2)
Figure 2
2. Carefully place display face down on protective surface.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K1S100/200 Monitor
Arm up to (and including) the display does not exceed 25 lbs
(11.34 kg) per arm. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
3. Connect faceplate to display
For flush mounting hole installation:
• Using Phillips screwdriver, carefully install four
M4x14mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 3)
Figure 3
release tab
1
1
(B) x 4
quick connect
faceplate
(for flush mounting holes)
3