CHIEF AVMW, Руководство по установке

Страница: 5 / 16

Installation Instructions AVMW
5
Install AVMW Box
1. Use retro ring template sheet (included with Raco® retro
ring packaging) to trace hole to be cut at desired mounting
locations. (See Figure 2)
NOTE:
AVMW must be installed within 10’ of the AVMA input
box so that the cables can be easily attached from the
AVMA to the AVMW. The AVMW should be installed at
lightswitch height. (See Figure 1)
NOTE:
If AVxTR (assisted listening device) is to be installed,
refer to AVxTR installation instructions to install AVxTR
module into AVMW prior to installation into wall!
Figure 1
2. Use drywall cutter to cut hole at marked location on wall.
(See Figure 2)
Figure 2
3. Connect retro ring to electrical box outlet by removing two
screws from box and using those screws to connect ring to
box. (See Figure 3)
Figure 3
4. Remove knockout from electrical box and route 48" CAT5e
cable from AVMA through hole.
IMPORTANT ! : In order to comply with building codes, it
is highly recommended that a conduit and/or strain relief
clamps are used to route cables through electrical boxes.
5. Place electrical box into cut hole and secure using retro
ring. Turn screws clockwise to extend work wings and
secure box to wall. (See Figure 4)
Figure 4
6. Connect 48" CAT5e cable from AVMA to AVMW. (See
Figure 5)
light switch
height
electrical outlet
AVMA
AVMW
AVMV
height
1
2
template
electrical box
retro ring
4
extended
work wing