36
37
1
Position Carrier rear facing on
vehicle seat, with child properly
secured in Carrier.
2
Route Vehicle Lap Belt under
both Belt Guides, and buckle the
vehicle belt.
3
Tighten Vehicle Belt while
pushing Carrier firmly into
vehicle seat.
Put the vehicle belt in the locked mode,
see vehicle owner’s manual for more
information.
A tightly rolled towel may be used
under the front edge of the Carrier if
needed to adjust the angle of the
Carrier. Angle is correct when level
line on Carrier is level with ground.
4
Check Installation:
a
Level Line on Carrier MUST
be LEVEL with ground.
b
Vehicle belt MUST be TIGHT.
c
Carrier MUST be STABLE
and secure.
Uninstalling Base
Remove Carrier from Base
1
Loosen LATCH by lifting the
LATCH Release Lever and pulling
Base away from vehicle seat back.
2
Detach LATCH Connectors
by pressing the red button on each
LATCH Connector, and remove
Base from vehicle.
Storing LATCH
Insert LATCH Connectors into
storage pockets.
a
1
Pull LATCH Pull Strap to
secure LATCH Connectors.
2
Roll LATCH Pull Strap and
store in Pull Strap Storage Pocket.
NEVER travel with CHILD RESTRAINT unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
When not using LATCH, the LATCH Connectors and Pull Strap
MUST be stored properly.
1
2
1
a
2
a
INSTALLATION WITHOUT BASE
NEVER install CARRIER without Base using a non-locking
vehicle belt. The installation will NOT be secure. Refer to your
vehicle owner’s manual for detailed vehicle belt information.
INSTALLATION USING LATCH
a
b
2
3 4
