Page 12
For technical questions, please call 1-800-444-3353.
SKU 67431
ventilation whenever cutting
pressure treated lumber.
Designate a work area that is clean
2.
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
Secure loose workpieces using a vise
3.
or clamps (not included) to prevent
movement while working.
Verify that there are no utility lines or
4.
hardware in or near the workpiece.
This is especially critical for plunge
cuts.
Charging instructions
The Charger (SKU 67104) and
1.
Battery Pack (SKU 67120) are sold
separately. Please refer to the 67104
Charger manual for important safety
warnings and proper instructions on
charging the battery pack.
warning! do not use a different
2.
Charger or Battery pack to power
this tool.
general operating instructions
warning!
1.
to preVent
SeriouS injurY,
BeFore operation:
remove Battery pack.
a.
adjust Blade depth to extend
b.
beyond bottom of workpiece by
1/4” or less. Lock depth Knob
after adjustment.
make sure that all guards are in
c.
place and in proper working order.
tighten all knobs/bolts, including
d.
Blade Bolt, securely.
Install fully charged Battery Pack
2.
(67120, sold separately) into the back
of the handle.
Hold the saw with one hand on the
3.
Housing and the other hand on the
Handle.
Align Saw on cut line with the larger
4.
part of the workpiece to the left of the
Saw Blade.
Push the Trigger Lock to one side
5.
and squeeze the Trigger.
Allow the Blade to come up to
6.
full speed before contacting the
workpiece.
note:
To prolong Battery Pack life, stop
use and switch to fresh battery pack
as soon as performance decreases.
After completing the cut, release the
7.
trigger. Make sure that the Movable
Guard closes immediately.
To prevent accidents, turn off the
8.
tool and disconnect the Battery Pack
after use. Clean, then store the tool
indoors out of children’s reach.
