6.
NOTE: The Planer’s Motor may stall if the tool is improperly used. If the Motor
begins to stall, reduce the speed at which you are making the cut and/or reduce
the depth of the cut.
To Reverse Or Replace The Cutter Blades:
1.
The Planer is equipped with
two reversible Cutter Blades (part #64). Do not
attempt to sharpen old Blades. And always reverse or replace the Blades as a
set in order to avoid an imbalance of the Cutter (part #42).
(See Figures E, F,
and Assy. Diagram.)
2.
To reverse or replace the Cutter Blades (part #64), use an Allen Wrench to
loosen the three Bolts (part #62) that secure Blades and the Wedge (part #61) to
the Cutter (part #42).
3.
Slide the Cutter Blades (part #64) lengthwise out of the Wedge (part #61).
NOTE: Use a piece of wood to slide the Blades out in order to avoid cuts to your
fingers.
4.
Once the Cutter Blades (part #64) have been removed, clean the Blades, the
Wedge (part #61), and the Cutter (part #42) thoroughly before installing the new
Blades; thus, allowing for a more accurate Blade setting.
WEDGE (61)
BOLT (62)
FIGURE E
5.
When installing the two reversed or new Cutter Blades (part #64), it is important
that they be properly adjusted so that they align evenly with the Front Support
(part #31) and Rear Support (part #30).
(See Figure F and Assy. Diagram.)
6.
Slide the reversed or new Cutter Blades (part #64) lengthwise into the Wedge
(part #61). NOTE: Use a piece of wood to slide in the Blades in order to avoid
cuts to your fingers.
7.
Place a straight edge or piece of wood along the outside surface of the Front
Support (part #31) and Rear Support (part #30).
SKU 45376
PAGE 9
Brought to You by Augusta Flint
Содержание 45376
Страница 13: ...Brought to You by Augusta Flint ...
