SKU 99823
For technical questions, please call 1-800-444-3353.
Page 9
using the chisel and plane
attachment
Support Plate with
Magnets (29)
Motor Housing (1)
Base with Mounting
Holes (2)
Figure 6
1. Slide the Chisel and Plane
sharpening attachment into the Motor
Housing (1), making sure that the
latch snaps into the catch at the lower
side of the attachment.
Determine the existing blade bevel
2.
angle, back off the thumb screw and
slide the guide platform to the desired
angle, using the scale and indicator
on the face of the attachment.
Tighten the thumb screw.
note:
To redress the edge to an alternative
angle, use of a heavy-duty grinding
set-up is recommended.
Position the chisel against the side
3.
lip of the Support Plate (29) and slide
the chisel edge down to reach the
grinding wheel.
note:
The chisel should be perpendicular
to the grinding wheel. The magnet
on the Support Plate will support the
blade in position during set up, but
the blade must be held firmly by hand
during actual grinding.
Turn on the Power Switch (3) and
4.
allow the motor speed to stabilize.
Slide the Support Plate, making sure
5.
that blade edge touches the wheel.
note:
Do not force the blade onto the
Grinding Wheel.
Stop the motor and remove the
6.
blade to inspect for proper and
uniform bevel angle and sharp edge.
If necessary, bevel angle may be
slightly re-adjusted.
When sharpening cold chisels, stop
7.
the Motor, turn the blade upside
down, repeat steps 4 through 6 to
sharpen the other face.
To prevent accidents, after each use
8.
turn off the tool and disconnect it for
its power supply. Clean, then store
indoors out of children’s reach.
note:
For extra fine edge, use of whet
stone and honing oil is recommended
after completion of sharpening with
this tool.
