SKU 99683
for technical questions, please call 1-800-444-3353.
Page 10
maintenance and
serVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
to preVent
serious injurY
from accidental
operation:
turn the power switch of the
tool to its “off” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
to preVent serious
injurY from tool
failure:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
cleaning, maintenance, and
lubrication
Before eacH use,
1.
inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
If the bit breaks or wears down it will
2.
need to be changed. Remove the
hex bolt located in the center of the
Screwdriver with a 4mm hex key.
Hex Bolt
3. Pull the collet that holds the bit out
and remove the bit.
Bit
collet
4. Place the new bit in the collet and
reconnect the front casing.
after use,
5.
clean external surfaces
of the tool with clean cloth.
6.
warning! if the supply cord of
the charger is damaged, it must be
replaced only by a qualified ser-
vice technician.