Page 19
For technical questions, please call 1-800-444-3353.
SKU 98194
troubleshooting
problem
possible Causes
likely Solutions
Tool will not
start
No power at outlet.
1.
Cord not connected.
2.
Check power at outlet.
1.
Check that cord is plugged in.
2.
Tool operates
sporadically or
at low power
Low power supply or improper
1.
extension cords.
Worn or cracked Carbon Brushes.
2.
Check power supply and power cords.
1.
Check Carbon Brushes and replace as needed.
2.
Wood burns at
ends when cut
Dirty Blade.
1.
Material is binding.
2.
Clean Blade using blade cleaner or mineral spirits.
1.
Check position of work material on Table. Material
2.
must be flat, flush against Fence and supported on
ends.
Material frays
or chips out.
Finished side is down
1.
Blade is chipped or dull.
2.
Blade is inappropriate for material.
3.
Material is unsupported.
4.
Always have finished side of material up or facing
1.
you. Bottom and back side are prone to chip out.
Check for damaged teeth. Sharpen or replace
2.
blade.
Check blade manufacturer’s recommendations for
3.
material being cut. For cross cutting hard wood and
for precision cuts use a thin kerf blade with 60 or
more teeth.
Use a thin piece of sacrificial material, such as
4.
1/4” plywood, underneath or behind the material to
support the edges of the material as it is being cut.
Blade binds
slowing or
stopping saw.
Material is misaligned on the saw
1.
or ends are not supported.
Material is wet, contaminated or
2.
inappropriate blade is being used.
Material must be flat on table, flush against the
1.
fence and supported on both ends.
Check condition of material and check compatibility
2.
of blade to material.
Laser beam
not visible or
faint
Laser off.
1.
Laser’s lens dirty
2.
Outdoor area is too bright to see
3.
beam clearly.
Laser’s batteries are dead.
4.
Turn laser on.
1.
Clean laser’s lens.
2.
Use saw indoors.
3.
Replace laser’s batteries.
4.
Follow all safety precautions whenever diagnosing or servicing the tool.
disconnect power supply before service.
pleaSe read the Following CareFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROvIDED THE PARTS LIST AND ASSEMBLY DIAgRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES
ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS qUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS qUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISINg OUT
OF HIS OR HER REPAIRS TO THE ORIgINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISINg
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
