Page 8
SKU 96692
for technical questions, please call 1-800-444-3353.
assembly
Mount lamp housing (22) onto Bracket (27):
Bracket Attachment (26) comes attached to base of Lamp Housing (22). Fas-
ten Bracket Attachment (26) to Bracket (27) using Screw (2).
Repeat this same procedure for the second Lamp Housing (22).
Mount Bracket (27) to tripod (28):
Attach Bracket (27) to top of Tripod (28) using Attachment Knob (37).
note:
This Twin Head Worklight may be used with or without attaching to the Tripod
(28).
operating instructions
read the entire iMportant safetY inforMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
general operating instructions
This Worklight gets hot during use. Use caution when moving it to another work
area.
Position the Worklight on a flat, level surface that will support its weight.
Plug in the Worklight and turn on the Switch(s) (18).
Adjust the individual Lights up or down using Bracket Screw (23).
adjusting the tripod:
If using Tripod, adjust the Legs by twisting the Leg Adjustment Rings (39) at bot-
tom to loosen, pulling out or pushing in the legs and re-tightening the Adjustment Rings
(39). Use the same procedure when adjusting the height of the center tube. There are
two Post Adjustment Rings (40) to loosen if more or less height is needed. Be sure to
re-tighten all Adjustment Rings.
replace lamp tube (6):
Remove 4 Tap Screws (1) and Lens Assembly (parts 2,3,4 & ) away from the
Lamp Body. Pull out the burnt Lamp Tube (6) and insert an identical replacement Lamp.
Replace the Lens Assembly (parts 2,3,4 & ) and re-tighten the 4 Tap Screws (1).
1.
a.
b.
2.
a.
1.
2.
3.
4.
.
6.
