Page 7
SKU 95887
for technical questions, please call 1-800-444-3353.
unPaCking
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
asseMbly instruCtions
NOTE: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
warning!
Make sure the Power Switch of the tool is in its “OFF” position
and that the Oven is unplugged from its electrical outlet before making any adjust-
ments.
this Powder Coat oven does not come equipped with an electrical power plug.
Prior to using, this Oven requires the attachment of
a grounded, 3-prong, 220 Volt,
Power Plug
to its Power Electric Cord (10). For your safety, only a qualified, certi-
fied electrician should attach the Power Plug to the Electric Cord (10) attached to
this Powder Coat Oven. Never remove the grounding prong or modify the Plug in
any way. Do not use adapter plugs with the Power Plug. To comply with the National
Electric Code, and to provide additional protection from the risk of electrical shock,
the Power Plug should only be connected to a 220 Volt, 3-hole electrical outlet that
is protected by a Ground Fault Circut Interrupter (GFCI).
oPeration instruCtions
Connect the Powder Coat Oven to a proper 220V electrical outlet after having the
correct Power Plug attached to the Power Electric Cord (10).
Open the Oven Door and adjust Oven Racks to the correct height needed. Load the
middle shelf first, or if you have just a few items, load as close to the center of the
Oven as possible for even baking. Load Oven from center up and/or down.
Close Oven Door, close the Adjustable Vents located on the right and left sides of
the Oven Cabinet. See Illustration on page 13.
Turn the Main Switch (1) to it’s “ON” position and set the Thermostat (3) at the maxi-
mum temperature setting as recommended by the manufacturer of the particular
coating material you are using.
Check the Main “ON” Indicator Light (5) and Heaters “ON” Indicator Light (6), make
sure they are illuminated.
Turn the Fan Switch (2) to it’s “ON” position. CAUTION: You may want to leave the
Fan off if using a fine powder coat. Fine powders may be disturbed by the blowing
Fan, which may remove some powder causing flat (dull) places on the finished
product.
1.
1.
2.
3.
4.
5.
6.
