SKU 93726
For technical questions, please call 1-800-444-3353.
Page 9
To Charge The Battery:
The Battery (3) for the Blower must be fully charged for
10 to 12 hours
before
using the tool for the first time. Thereafter, subsequent charge times are also
from
10 to 12 hours
. Never charge the Battery for longer than 12 hours, as dam-
age to the Battery and/or tool will occur.
(See Figure E.)
To charge the Battery (3), make sure the Power Switch (5) of the Blower is in its
“OFF”
position.
(See Figure E.)
Plug the AC/DC Adapter’s (20) lead wire into the DC Socket (19) located at the
bottom of the tool.
(See Figure E.)
Plug the AC/DC Adapter (20) into the nearest 120 volt, grounded, electrical outlet.
(See Figure E.)
The
Red Light
on the Blower indicates the Battery (3) is being charged and will
stay on throughout the charging process.
(See Figure E.)
At the end of
10 to 12 hours
charge time, unplug the AC/DC Adapter (20) from
its electrical outlet. Then, remove the AC/DC Adapter’s lead wire from the DC
Socket (19).
(See Figure E.)
NOTE:
While charging the Battery (3), the Battery and AC/DC Adapter (20) may
feel warm to the touch which is normal during the charging process.
(See Figure E.)
1.
2.
3.
4.
5.
6.
7.
AC/DC ADAPTER (20)
DC SOCKET (19)
RED LIGHT
POWER SWITCH (5)
FIGURE E
To Operate The Blower:
Point the Blower Tube (11) toward the area to be cleared of dirt, leaves, and de-
bris. Then, simply turn the Power Switch to its
“ON”
position. The Blower will run
continuously until the Power Switch is turned to its
“OFF”
position.
1.
