SKU 93726
For technical questions, please call 1-800-444-3353.
Page 5
The charge time for the Battery (3) is from 10 to 12 hours.
Do not charge the
Battery for over 12 hours as damage to the Battery and/or Blower may result.
Always switch to a fresh Battery (3) when tool performance begins to di-
minish.
Severe heat is most destructive to a Battery. The more heat generated,
the faster the Battery loses its power. A Battery that gets too hot can be perma-
nently damaged. Never over-discharge a Battery by using the tool even after
tool performance is decreasing. Never attempt to discharge a tool’s Battery by
leaving the Power Switch on. When tool performance begins to diminish stop the
tool, recharge the Battery, and use the fresh Battery for optimal performance.
Battery (3) leakage may occur under extreme usage or temperature condi-
tions. Do not attempt to charge a leaking Battery.
If Battery fluid comes
in contact with skin, wash with soap and water and rinse with lemon juice and
vinegar. If the fluid comes into contact with eyes, flush with water for several min-
utes and contact a physician immediately.
Never burn a Battery, as it can explode in a fire.
Contact local solid
waste authorities for instructions on correct disposal of a Battery.
Do not operate the Blower without its Blower Tube (11) attached.
Do not operate the Blower while it is attached to the AC/DC Adapter (20).
Do not operate the Blower indoors.
WARNING!
People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
WARNING!
The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
5.
6.
7.
8.
9.
10.
11.
12.
13.
GROUNDING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric shock.
Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. Do not modify the power cord plug provided with the tool.
Never remove the grounding prong from the plug. Do not use the tool if the power
cord or plug is damaged. If damaged, have it repaired by a service facility before
use. If the plug will not fit the outlet, have a proper outlet installed by a qualified
electrician.
