14.
Never leave the Chipper/Shredder unattended when it is plugged into an
electrical outlet.
Turn off the machine, and unplug it from its electrical outlet.
SKU 92281
For technical questions, please call 1-800-444-3353.
PAGE 9
12.
Keep all electrical connections dry and off the ground.
13.
Do not handle the Power Switch (47) with wet hands.
15.
Allow the Blades (15) to spin up to full speed before feeding limbs into
them.
When turning off the Chipper/Shredder, allow the Blades to spin down
and stop on their own. Do not press against the Blades with limbs or any other
objects to stop them.
16.
Do not force limbs into the Blades (15) when cutting.
Apply moderate pres-
sure, allowing the Blades to cut without being forced.
17.
Never attempt to remove material stuck in the moving parts of the Chipper/
Shredder while it is plugged in.
18.
Never stand on the Chipper/Shredder.
Serious injury could result if the Chip-
per/Shredder is tipped.
19.
Industrial applications must follow OSHA requirements.
20.
Keep all bystanders and animals safely away while operating the Chipper/
Shredder.
21.
For your safety:
In extreme working conditions, sensors in the Chipper/Shredder
will automatically switch off the Motor to prevent overheating. In this event, turn the
Power Switch (47) to its “OFF” position. Unplug the electrical cord and wait five
minutes or until the Motor has cooled. Clear the machine of all debris. Plug in the
electrical cord and depress the Circuit Breaker. Then, turn the Power Switch to its
“ON” position to resume cutting.
NEVER attempt to disable the Circuit Breaker.
22.
Performance of this machine (if powered by line voltage) may vary
depending on variations in local line voltage Extension cord usage may
also affect machine performance.
23.
Wait for sufficient time after shut down before performing any maintenance
on the Chipper/Shredder.
The Blades (15) do not stop immediately after turning
off the power and unplugging the machine. Avoid injury by performing
maintenance on the Chipper/Shredder only when all parts are cool to the touch.
24.
Avoid entanglement. Feed only one limb at a time into the Hopper
(1).
Feeding two or more limbs at a time can entangle hands in the
limbs, pulling fingers and hands downward into the spinning Blades (15).
