16.
Always disconnect the Impact Wrench from its electrical supply
source before changing Sockets or performing any maintenance
on the tool.
17.
The Impact Wrench is designed for use with a 12 volt DC system
only. Do not attempt to use any other type of electrical system.
18.
To avoid overheating the tool’s Motor (15) do not use the Impact
Wrench continuously for over 8 minutes.
19.
Prior to performing maintenance or repair on a vehicle, make
sure to read and understand all instructions and safety precau-
tions as outlined in the vehicle manufacturer’s
owner’s manual.
20.
This Impact Wrench is designed for
emergency
purposes only.
For non-emergency purposes, use an industrial/commercial class
Impact Wrench.
21.
In the event of an emergency, move the vehicle a safe distance
from the roadside and away from all other traffic. Park the
vehicle on dry, flat, level, ground. Turn off the vehicle, and set
the emergency brake before attempting to change a flat tire.
22.
Avoid accidental electrical shock.
Keep the Impact Wrench dry at
all times.
23.
Avoid eye injuries.
Always wear ANSI approved safety impact eye
goggles when working with a vehicle battery which under certain
circumstances can explode, causing possible serious burns and
injuries to the eyes.
24.
Avoid contact with battery acid.
If splashed, immediately wash
affected area with clean water. Continue washing until medical help
is available.
25.
Avoid working alone.
If an accident occurs, an assistant can bring
help.
26.
When using a power hand tool, always grasp the tool firmly with
both hands to maintain control of the tool.
27.
WARNING!
People with pacemakers should consult their
physician(s) before using this product. Operation of electrical tools in
close proximity to a heart pacemaker could cause interference or
failure of the pacemaker.
28.
WARNING!
The warnings, precautions, and instructions discussed
in this manual cannot cover all possible conditions and situations that
may occur. The operator must understand that common sense and
caution are factors, which cannot be built into this product, but must
be supplied by the operator.
SKU 90672
PAGE 4
90672.p65
11/20/03, 11:13 AM
4