Page 10
For technical questions, please call 1-800-444-3353.
SKU 68821
3. To clear dust from accumulating along
the cut line, use the Dust Blower to
blow a stream of air onto workpiece.
4. To activate, turn the Dust Blower switch
to the on (horizontal) position. To turn
it off, turn the switch back to the off
(vertical) position. See Figure 7, below.
Figure 7
Dust Blower Switch
Bevel and Metal Cutting
1. Use the included Hex Key to loosen the
Cap Screw (24) on the bottom of the
Base Plate (22). Tilt the base, allowing
for bevel cuts between 0 and 45°.
2. Retighten the Cap Screw once the
desired angle is reached.
3. For metal cutting, be sure to use a coolant
such as cutting oil during use. Failure
to add coolant will lead to greater blade
wear. If desired, grease the underside of
the workpiece in place of adding coolant.
4. When finished with the Jigsaw, unlock and
release the Trigger to stop the Jigsaw. Wait
until the Saw Blade stops completely. Turn
the Laser Switch to its “OFF” position. Then,
remove the Jigsaw from the workpiece.
5. To prevent accidents disconnect the
power cord after use. Clean, then store
the tool indoors out of children’s reach.
Replacing Laser Batteries
1. Push Laser Shell up and lift off of housing.
2. Remove the two AAA batteries from the inside
of the Laser Shell (45) and replace with two
new AAA batteries. See Figure 8, above right.
CAUTION!
Position batteries
according to indicated polarity.
3. Slide Laser Shell back onto housing.
Figure 8
Batteries
Laser Shell (45)
Maintenance and Servicing
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Unlock and release Trigger and
unplug tool from its electrical outlet
before performing any inspection,
maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE: Do not use
damaged equipment. If abnormal noise
or vibration occurs, have the problem
corrected before further use.
Cleaning, Maintenance,
and Lubrication
1.
BEFORE EACH USE,
inspect the general
condition of the tool. Check for loose
hardware, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any other
condition that may affect its safe operation.
2. Inspect the Saw Blade. Replace with
a new Saw Blade when needed.
3.
AFTER USE,
wipe external surfaces
of the tool with clean cloth.
4.
WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
