SKU 66745
For technical questions, please call 1-800-444-3353.
Page 14
general Operating instructions
Prior to operating the Sprayer, know
1.
in advance how to release pressure
in the unit’s system:
Engage the Safety Lock (18B) on
•
the Spray Gun.
Turn the Power Switch (33A) to its
•
“OFF” position.
Turn the Pressure Adjust Knob
•
(69A) to its “OFF” setting.
If not already done, insert Spray
•
Valve (23B) into top of Guard (24B)
and turn to “spray” mode. See pho-
tos on page 12.
Unlock the Spray Gun by turning
•
the Safety Lock to the unlocked
position.
Hold the Spray Gun firmly against
•
the side of a grounded container.
See Figure B, below.
Spray the paint into the container to
•
relieve the system pressure.
Lock the Spray Gun by turning the
•
Safety Lock to the locked position.
Turn the Prime/Spray Knob (39A) to
•
its “PRIME” position.
impOrtant:
2.
Do not run the Sprayer
dry for more than
30 seconds
. Doing
so can damage the Pump Packing.
nOte:
3.
Before spraying the actual
workpiece, it is recommended to test
spray on scrap material.
Unlock the Trigger Safety Lock (18B)
4.
by pulling back on the tab of the Lock
and turning it to either side.
Face the Spray Tip toward the
5.
item to be painted. (See bottom photo
on page 12.)
Hold the Spray Gun about 14-16
6.
inches from and at a right angle to
the item.
Move the Spray Gun first, then pull the
7.
Trigger to spray a test pattern.
Slowly increase Pump pressure until
8.
coverage is uniform.
To align the spray pattern, relieve
9.
pressure on the system. Loosen the
Guard (24B) on the Spray Gun. Align
the Guard horizontally to obtain a hori-
zontal spray pattern. Align the Guard
vertically to obtained a vertical spray
pattern.
painting tips
Successful spray painting is a skill
1.
which requires knowledge of your
equipment, familiarity with your paint
materials and experience.
Differences in paints, work materials
•
and environmental conditions make
every painting task unique. For best
results, practice with your painting
mixture on scrap material before
beginning to paint your workpiece.
Figure B
Warning!
alWays grOund
the cOntainer
When using
Oil-Based paint & sOlVent
nOte:
must Be
metal BucKet
Or cOntainer.
