SKU 66118
For technical questions, please call 1-800-444-3353.
Page 6
SpECIFICatIOnS
Voltage
6VDC
Batteries Required
4 “AA” 1.5V Alkaline or
Rechargeable Batteries
(not included)
Speed
150 RPM (No Load)
Max. Torque
25-30 in/lb.
Bit Sizes
4 (PH1, PH2, PZ1, PZ2)
unpaCKIng
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
SEt-up InStRuCtIOnS
Read the EntIRE ImpORtant
SaFEtY InFORmatIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO pREVEnt
SERIOuS InjuRY
FROm aCCIDEntaL
OpERatIOn: Remove
batteries before making any
adjustments to the tool.
note:
For additional information regard-
ing the parts listed, refer to Assembly
Diagram near end of this manual.
Installing Drill Bits
Push selected Drill Bit into Chuck un-
1.
til the bottom touches end of Chuck.
If necessary, another Drill Bit can be
2.
slid into the Bit Holder (24) on the
top of the housing for easy access.
please note:
Do not attempt to snap-
fit the Bit into the Holder.
Installing Batteries
To insert the batteries, press down on
1.
the tab of Battery Cover (31) located
at the bottom rear of the handle.
Lift Battery Cover off and insert four
2.
“AA” batteries into chamber, making
sure to follow indicated polarities.
WaRnIng!
3.
Do not install batteries
of different types, charge levels or
capacities together.
Slide the Battery Cover over battery
4.
chamber until it snaps into places.
OpERatIng InStRuCtIOnS
Read the EntIRE ImpORtant
SaFEtY InFORmatIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO pREVEnt
SERIOuS InjuRY
FROm aCCIDEntaL
OpERatIOn: Remove
batteries before performing
any inspection, maintenance,
or cleaning procedures.
Once the Drill Bit has been installed
1.
and the workpiece is secured by
clamps or to a stable platform, acti-
vate the Cordless Screwdriver.
To fasten screws, press the top
2.
(Forward) Direction Button (33). The
Screwdriver will continue to function
until you take your finger off button.
