Page 7
For technical questions, please call 1-888-866-5797.
Item 65818
S
AFET
y
W
EL
d
IN
g
C
UTTIN
g
M
AINTENANCE
S
ETU
p
2. While standing to one side, “crack” each
cylinder valve. “Cracking” is to quickly open
and close the valve, allowing a small amount
of gas to escape and clearing the valve of any
foreign material.
WARNINg!
If oil or grease
is found, discontinue using cylinder and
immediately contact your gas supplier.
Assembly Step 2: Crack Each Cylinder Valve
Briefly open valve to clean,
then close valve.
WARNINg!
KEEp WRENCH ON
ACETyLENE CyLINdER’S VALVE whenever cylinder
is in use to allow quick shutoff in case of emergency.
NOTE:
Wrench not included.
3. Attach the Green labeled Oxygen Regulator (9)
to the Oxygen Cylinder (13) and the
green oxygen hose to the regulator.
4. Attach the Red labeled Acetylene Regulator (10)
to the Acetylene Cylinder (14) and the
red acetylene hose to the regulator,
tighten counterclockwise - threads are reversed
.
5. To set up the Torch Handle (7):
a. Remove the plastic inlet covers.
b. Make sure both check valves are
in place on the torch handle.
c. Connect the green-oxygen hose to the oxygen
Check Valve (11) on the Torch Handle.
d. Connect the red-acetylene hose to the acetylene
Check Valve (12) on the Torch Handle,
tighten counterclockwise -
threads are reversed
.
Check Valve
(OX) (11)
Oxygen
Hose
(green)
Check Valve (AC) (12)
Acetylene Hose (red)
Torch
Handle (7)
Assembly Step 5: Torch Handle Setup
6a. Welding Setup
Connect the Welding Nozzle (8)
to the Torch Handle.
Assembly Step 6a: Welding Setup
Welding
Nozzle (8)
Torch Handle (7)
6b. Cutting Setup
WARNINg! BEFORE CONNECTINg,
make sure the two
O-Rings on the end of
the Cutting
Attachment (5) are not
damaged or missing,
otherwise gases will mix
inside the Torch Handle
and result in flashback
or backfires.
Connect the Cutting Attachment (5) to the Torch Handle.
Then, connect the Cutting Tip (6)
to the Cutting Attachment (5).
Cutting
Attachment (5)
Torch
Handle (7)
Cutting Tip (6)
Assembly Step 6b: Cutting Setup
7.
Before operation, the leak tests on the
following pages must be done after connection
to check for leaks in the system.
Cutting
Attachment (5)
O-Rings
