Page 18
For technical questions, please call 1-888-866-5797.
Item 65818
S
AFET
y
W
EL
d
IN
g
C
UTTIN
g
M
AINTENANCE
S
ETU
p
Maintenance Instructions
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM ACCIdENTAL OpERATION:
Close the oxygen, then acetylene and allow the torch to cool completely, then disconnect
the hoses before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
do not use damaged equipment. If abnormal noise, vibration, or leaking
gas occurs, have the problem corrected before further use.
1.
BEFORE EACH USE,
inspect the general condition
of the Torch Kit. Check for loose hose connections,
cracked or worn hoses, and any other condition that
may affect its safe operation.
If any abnormal condition occurs or is noticed, have
the problem corrected before further use.
do not use damaged equipment.
2. Periodically use a tip cleaner to clean
out Cutting Tip and Welding Nozzle.
3. To clean the outer body of the Cutting Attachment,
use a clean, dry, cloth. Do not immerse any
part of the Cutting Attachment in ANY liquid.
do not use solvents or other flammable
agents to clean the Cutting Attachment.
MAINTENANCE CHART
Maintenance Type
Before
Use
After
Use
Inspect tool for damage.
X
X
Use tip cleaner to
clean tip opening.
X
X
Wipe off with clean, dry cloth.
NEVER USE SOLVENTS
TO WIPE DOWN THIS
CUTTING ATTACHMENT.
X
Troubleshooting
problem
possible Causes
Likely Solutions
Before turning
on Torch, gas
odor is noticed.
1. Hose connections loose.
2. Crack in hose.
3. Cylinder leak at neck.
1. Tighten all connections.
2. Check hoses. If any cracks are found, replace entire hose.
DO NOT PATCH OR TAPE GAS HOSES.
3. Check neck area of cylinders.
If cracks or damage are found, do not use.
Secure upright, in a well-ventilated area, well away from
sources of ignition. Contact gas supplier IMMEDIATELY.
Replace cylinders before proceeding with work.
Flame is irregular. 1. Cutting tip clogged or dirty.
2. Gas low.
1.
Close gas, oxygen first, then acetylene.
Let Torch cool completely.
Remove Tip, check for dirt and debris.
Use tip cleaner to clean Tip or replace if necessary.
2.
Check gas level and refill if needed.
Follow all safety precautions whenever diagnosing or servicing the tool.
disconnect air supply before service.
