Page 12
For technical questions, please call 1-888-866-5797.
Item 61441
SAFET
y
O
PERA
TION
M
AINTENAN
c
E
SETUP
General Operating Instructions
TO PREVENT SERIOUS INJURy:
Wear ANSI-approved safety goggles, ear protection, steel-toe boots, and dust mask during use.
Keep feet clear of Breaker Hammer.
Keep children and animals well clear of the work area.
1. Check Chisel for dullness, cracks, or other damage.
cAUTION!
Dull tipped chisels can cause unnecessary
chisel movement, resulting in tool wear and
possible injury. Use only sharp tipped chisels.
2. Clearly mark the work area.
3. Make sure that the Trigger is in
the off-position, then plug the tool into an
outlet on a circuit rated to 20 amps.
4. Set the bit against the work area.
cAUTION!
Keep power cord away
from moving machines.
5. Place one hand on the Side Handle and
the other hand around the Main Handle.
6. Press down on the Trigger.
Note:
Trigger does not lock. Keep pressure
on the Trigger to keep running the tool.
7. Push the tip forcibly down to begin striking material.
NOTIcE:
Running tool with no load or “empty
blows” will damage the Breaker Hammer.
cAUTION!
Once activated, do not press,
bear down, or thrust forcibly against the work
surface. Allow the Breaker Hammer’s own
weight to supply the needed force.
Note:
If the Breaker Hammer has not been used for
a long time or is being used in low temperatures,
the tool may require 3-5 minutes to warm up.
NOTE:
Carbon Brushes will wear during use.
The Breaker Hammer will stop working if the
Brushes are worn.
This does NOT mean Breaker
Hammer is malfunctioning or broken, only that
the worn Brushes will need to be replaced with
the included Brushes by a qualified technician.
8. When work is complete, release the Trigger.
The Trigger is spring-loaded and will return
to the off position automatically.
9. To prevent accidents, turn off the tool and
disconnect its power supply after use.
10. Clean, then store the tool indoors
out of children’s reach.
Содержание 61441
Страница 1: ......
