4.
Do not attempt to connect or disconnect load connections while standing in
water, or on wet or soggy ground.
5.
Do not touch electrically energized parts of the Generator and interconnecting
cables or conductors with any part of the body, or with any non-insulated
conductive object.
6.
Connect the generator only to a load or electrical system (120 volt and 240 volt)
that is compatible with the electrical characteristics and rated capacities of the
Generator.
7.
Before servicing equipment powered by the Generator, disconnect the equipment
from its power input.
8.
Keep all electrical equipment clean and dry. Replace any wiring where the insu-
lation is cracked, cut, abraded or otherwise degraded. Replace terminals that
are worn, discolored, or corroded. Keep terminals clean and tight.
9.
Insulate all connections and disconnected wires.
10.
Guard against electric shock. Prevent body contact with grounded surfaces such
as pipes, radiators, ranges, and refrigerator enclosures.
11.
Use only Class BC or Class ABC fire extinguishers on electrical fires.
12.
WARNING! People with pacemakers should consult their physician(s)
before using this product. Electromagnetic fields in close proximity to a heart
pacemaker could cause interference to or failure of the pacemaker.
INSTALLATION
1.
NOTE: Prior to powering tools and equipment, make sure the Generator’s rated
voltage, wattage, and amperage capacity (120V/20AMPs and 240V/20 AMPs) is
adequate to supply all electrical loads that the unit will power. If powering ex-
ceeds the Generator’s capacity, it may be necessary to group one or more of the
tools and/or equipment for connection to a separate Generator.
SKU 54516
PAGE 11
2.
Electrical and other permits may be required for the installation of emergency
power systems. Investigate the local building and electrical codes before install-
ing this unit. Installation must be completed by licensed contractors.
3.
WARNING! The Generator weighs 167 pounds. Use care and the proper
lifting or hoisting equipment when moving it to the installation location. Always
connect hoist lines to the Frame (21) of the Generator. It is recommended that 2 or
more people assist when moving the Generator.
