Page 7
For technical questions, please call 1-888-866-5797.
46092
ANSI Z87.1-2015
Variable Shade 4/9-13
46092
Adjusting Headband
Adjust the Headband so that the helmet
is seated securely on your head as low
as possible and close to your face.
Adjust the Headband width by turning the
Headband Adjustment Knob to make sure the
Front Lens Cover is aligned with your eyes.
Adjust the Headband height by tightening or loosening
the top strap until the Helmet fits snug on your head.
Once the Headband is properly adjusted, lower the
Helmet over your face until the proper angle is found.
Then turn the Tension Adjustment Knobs on either side
of the helmet, locking the helmet’s angle in place.
Tension
Adjustment
Knob
Headband
Adjustment
Knob
Top Strap
Figure B
Time Delay and Sensitivity
At the moment the welding operation is started, the
filter screen automatically changes from clear to dark.
The operator can vary the amount of time it takes
the filter to return to a clear state and the sensitivity
of the sensor using the controls inside the helmet.
The Sensitivity setting changes the amount
of light needed to make the filter react.
Dark to Clear Adjustment Knob
Adjusts the speed the lens changes.
Minimum: 0.1 seconds
Maximum: 0.9 seconds
Sensitivity Adjustment Knob
Adjusts the amount of light needed
to activate the lens to darken.
Figure C
Solar Cells
This Welding Helmet utilizes high performance solar
cells as its power supply, and has a built-in 3V lithium
battery as power backup. No change of battery is
needed. Under normal welding conditions, users
can expect a battery lifetime of more than 6 years.
Shades
User-selectable variable shades from 9 to 13 are
adjusted with the Shade Control Knob (shade variable).
This product is in full conformity with related DIN, ISO,
EN379 safety standards and ANSI Z87.1-2015 standard.
Filters
The ultra high performance of UV and IR
Auto-Darkening filters provides the user’s eyes and face
with full protection against UV and IR radiation during
the entire welding process, even in clear state. The
UV/IR protection level is up to shade 15 at all times.
Magnifying Cheater Lens
To attach a magnifying cheater lens (sold separately)
to the inside of the helmet, slide the cheater lens
into place underneath the tabs located on the lower
right and left sides of the Lens Retaining Frame.
SAFETY
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
