Cheyenne Sol Nova, Руководство по эксплуатации

Страница: 12 / 19

27 EN
There are three ways to supply power to
the SOL Nova:
Thir
d party power unit
Cheyenne Power Unit
Capable adapters
provided
Y cable adapter
1. Connecting it to a Cheyenne Power Unit
with the connecting cable provided in
the scope of delivery (recommended)
2. Connecting it to an third-party power
unit with the 6.3 mm jack and the cable
adapter supplied
The external power unit must deliver
approx. 5 to 12.6 V direct current and
the required start-up current indicated
in chapter 4.1. If more than about
12.6 V is connected to the SOL Nova, it
will shut down automatically.
3. Connection to a third-party power
supply using the optionally available
Y-cable adapter with banana plugs
The red banana plug must be
connected to the positive terminal
while the black banana plug must be
connected to the negative terminal of
the third-party power unit.
!
Connect the socket of the connecting
cable (supplied) to the connection on
the drive unit of the SOL Nova.
!
Plug the jack of the connecting cable
fully into the output socket on the
power unit.
If you are using an third party power unit,
connect up its terminals correctly, as
described in the operating instructions
of the third party power unit.
!
Connect the power unit to the mains
power supply.
!
Cover the Power Unit or the third party
power unit with a plastic sheet.
5.4 Fitting the protective hose
ATTENTION
Damage to drive caused by fluid
If fluid gets inside the drive or on the
connection, this can corrode the electri-
cal and mechanical components.
!
Always use a protective hose with
a diameter of 34 to 40 mm. This
corresponds to a hose width of 54 to
63 mm.
!
Remove the connecting cable from the
SOL Nova.
!
Cut o ff a section of protective hose of
an appropriate length.
!
Slide this section of protective hose
completely over the connecting cable.
!
Completely unscrew the handle (1)
from the drive.
!
Reconnect the connecting cable and its
fitted protective hose to the SOL Nova.
1
Cheyenne SOL Nova