Chevrolet 2015 Silverado, Дополнение к руководству пользователя, Страница: 21 / 40

21 Driving and Operating 21
OFF
ON
Export power may be used until the
high voltage battery reaches a low level
(approximately 22%). At that point, a
warning buzzer starts beeping slowly. At
19.5%, the buzzer beeps faster. At 18.5%,
the buzzer beeps very fast. The export
power will switch off at 18%. In order to
continue, insert the truck key into the
ignition (not the power export panel
key) and turn to the On/Run position.
Make sure the gear selector is in P (Park)
with the park brake set. The engine will
start to drive the high voltage generator.
Export power will resume until the truck
runs low on fuel. Again, an alarm will
sound and the truck should be driven
to a fuel source. After refueling, export
power panel usage may be resumed.
240 Volt Circuit Breakers
If a circuit breaker is tripped, it will have
to be reset. Before resetting the circuit,
make sure that everything that was
plugged into the export power panel
is unplugged and turned off . Reset the
circuit breaker, slowly plug everything
back in, and turn it on. If the circuit
breaker trips again after you begin
plugging things in and turning them
on, you know you have overloaded the
circuit.
CAUTION: Make sure the
truck is in a well ventilated
area before allowing the engine
to start.
CAUTION: Remove tools and
power tools and close cover
before driving away.
CAUTION: The export power
key must be in the off
position for the truck to
drive.
Key Switch
The export power panel features a
barrel key lock that will help prevent
unwanted use of the outlets. It is a two
position switch that can be removed in
either the ON or OFF position. Wait at
least 45 seconds after turning off the
ignition before engaging export power.
If the power panel is not in use, the key
switch should be in the OFF position,
and the key removed from the lock.