Chevrolet 2015 Silverado, Дополнение к руководству пользователя, Страница: 17 / 40

17 Driving and Operating 17
Note: Even when fully
charged, the EVSE should
remain plugged in. This will
help ensure the battery is
within optimal temperature
range and maximize the
battery life.
Note: Keep water and debris
away from the charging
connectors, both on the
vehicle and the EVSE.
Note: When the vehicle is
started, the “state of charge”
indicator should point to
100% if the charge cycle has
been completed. If the
“state of charge” shows 90%
after the charge has been
completed, see Vapor
Canister Purge instructions
on page 6.
For other EVSE charging equipment,
refer to the manufacturer’s instructions.
CHARGING
PROCEDURE
1. Park on a level surface inside
a garage or protected area if
possible.
2. Turn the vehicle off . Turn off
Export Power if it in use.
3. Wait at least 45 seconds.
4. Open the charge port cover
located at the left front (driver
side) by pressing in and releasing.
The vehicle is charged using
an onboard charger and an
EVSE (Electric Vehicle Supply
Equipment) as a power supply.
5. Align the EVSE handle with the
charge port, and push in until
a click is heard. Make sure the
handle is completely inserted and
properly seated to ensure a safe
connection.
6. Charge Port LEDs indicate the
charging status as follows:
Blinking green: Charge in progress
Solid green: Charging complete
Solid red: Charging fault
7. Once the battery has reached a
‘full charge,’ the green charging
light on the EVSE will become
solid green. Keep the EVSE
plugged in until you are ready
to drive the vehicle. Depress the
button on the handle and remove
it from the charge port. Close the
charge port cover.
Charging times will vary based on
EVSE type, temperature, and initial
state of charge.