Chevrolet 2010 Cobalt, Руководство пользователя

Страница: 289 / 456

A. Engine Air Cleaner/Filter (2.0L Turbo Engine) on
page 6
‑ 23 or Engine Air Cleaner/Filter
(2.2L Engine) on page 6 ‑ 25 .
B. Engine Oil Dipstick. See “ Checking Engine Oil ”
under Engine Oil on page 6 ‑ 17 .
C. Engine Cooling Fan. See Cooling System on
page 6 ‑ 28 .
D. Engine Oil Fill Cap. See “ When to Add Engine Oil ”
under Engine Oil on page 6 ‑ 17 .
E. Brake Master Cylinder Reservoir. See “ Brake
Fluid ” under Brakes on page 6 ‑ 37 and Hydraulic
Clutch on page 6 ‑ 27 .
F. Engine Compartment Fuse Block on page 6 ‑ 127 .
G. Remote Positive (+) Terminal. See Jump Starting
on page 6 ‑ 42 .
H. Remote Negative ( − ) Terminal. See Jump Starting
on page 6 ‑ 42 .
I. Engine Coolant Surge Tank. See Cooling System
on page 6 ‑ 28 .
J. Windshield Washer Fluid Reservoir. See “ Adding
Washer Fluid ” under Windshield Washer Fluid on
page 6 ‑ 36 .
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil level at each
fuel fill. In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop.
See
Engine Compartment Overview on page 6 ‑ 14
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If this is not done, the
oil dipstick might not show the actual level.
2. Pull out the dipstick and clean it with a paper towel
or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.
6-17