2-25
Two-Speed Rear Axle
1. With the engine running, shift the two
-
speed rear
axle into low. To be sure it’s in low, you’ll need to
move the vehicle in gear just a little.
2. Hold the regular brake pedal down with your
right foot.
3. Apply the parking brake.
4. Shift the transmission to NEUTRAL (N) or
PARK (P).
Hydraulic Brakes (Option)
If your vehicle has hydraulic brakes, it has a parking
brake lever or an electric/hydraulic parking brake. The
lever is located below the instrument panel to the left of
the steering column. The electric/hydraulic parking
brake knob is located to the right of the steering column.
Your vehicle may also be equipped with an automatic
transmission which has a shift lever. This lever will have
a PARK (P) position on the shift indicator. When the
PARK (P) position is selected with the shift lever, the
parking brake is automatically applied.
Propshaft Brake Burnish Procedure
It is recommended that the propshaft
-
mounted parking
brake be burnished as part of the new vehicle break
-
in.
The parking brake will work best after it has been
burnished following these instructions:
Make 10 stops, using the parking brake hand lever, from
20 mph (32 km/h) about 2 1/2 miles (4 km) apart.
Between stops, drive the vehicle at 20 mph (32 km/h).
Lever Operated Parking Brake
To apply the parking brake,
pull the lever all the way up.
The PARK BRAKE light
will come on when the
parking brake is applied.
Then shift the transmission
to NEUTRAL (N) or
PARK (P).
The vehicle must be stopped when applying the parking
brake, except while burnishing the parking brake linings
(see “Propshaft Brake Burnish Procedure” in the Index).
Содержание 2000 C-Series
