Chevrolet 1963 Corvette, Руководство по ремонту и настройке

Страница: 216 / 346

198 CHASSIS ELECTRICAL
3. Remove the rubber plug from the front
of the wiper door actuator, insert a screw
driver and push the internal piston rearward
to actuate the wiper door open.
4. Remove the wiper arm and blade as
semblies from the transmission.
5. Remove the plenum chamber air intake
grille, or screen, if so equipped.
6. Loosen the nuts retaining the drive rod
ball stud to the crank arm and detach the drive
rod from the crank arm.
7. Remove the transmission retaining
screws, or nuts, then lower the drive rod as
semblies into the plenum chamber.
8. Remove the transmission and linkage
from the plenum chamber through the cowl
opening.
9. To install reverse the above procedure.
Make sure the wiper assemblies are installed
in the park position.
1973-84
1. Make sure the wiper is in the park po
sition.
2. Disconnect the battery ground cable.
3. Open the hood and remove the plenum
chamber screen.
4. Loosen the nuts retaining the ball sock
ets to the crank arm and detach the drive rod
from the crank arm.
5. Remove the transmission nuts, then lift
the rod assemblies from the plenum cham
ber.
6. Remove the transmission linkage from
the plenum chamber.
7. To install reverse the removal proce
dure. Make sure the wipers are in the park
position.
Ignition Switch
REMOVAL AND INSTALLATION
1964-67
NOTE: See Chapter 8 for steering column
switch removal.
1. Disconnect the ground cable from the
battery.
2. Remove the cylinder by placing it in the
lock position and inserting a stiff wire in a
small hole to depress the plunger. Turn the
cylinder counter-clockwise until the cylinder
can be removed.
3. Remove the holding nut with Tool J-
7607 or its equivalent.
4. Pull the switch from under the dash and
remove the connector.
Unlocking the ignition switch connector—1964-68
5. Using a screwdriver, unsnap the lock
ing tangs.
6. To install reverse the above procedures
1968
1. Open the battery storage compartment
and disconnect the ground cable from the
battery.
2. Remove the screws securing the "Cor
vette" cover plate in the top center of the
cluster assembly.
3. Remove the ash tray and retainer.
4. Remove the radio and bracket.
5. Remove the lock cylinder by position
ing the switch in the "ACC" position and in
serting a wire in the cylinder face small hole.
Push in on the wire to depress the plunger
and continue turning the key counterclock
wise until the lock cylinder can be removed.
6. Remove the ignition switch bezel nut
and pull the ignition switch out from under
the dash.
7. Using a screwdriver unsnap the "theft
resistant" locking tangs on the connector and
unplug the connector.
8. To install reverse the above procedure.
SEAT BELTS
Warning System
1972-73
The seat belt warning system consists of lap
belt retractor switches, a pressure-sensitive
switch underneath the right-hand front pas-
senger's seat, a warning lamp and a buzzer.
On manual transmission-equipped cars, the
circuit is wired through the ignition switch,