CHESTER Super Lux Mill, Руководство по эксплуатации

Страница: 6 / 17

6
Cleaning
1. This machine has been coated with a heavy grease to protect it when it is delivered, this
coating should be completely removed before operating the machine. Commercial
degreaser, kerosene or similar solvent may be used to remove the grease from the
machine but avoid getting solvent on belts or other rubber parts.
2. After cleaning, coat all bright work with a light lubrication, lubricate all points with a
medium consistency machine oil.
Lubrication
All ball bearings in your mill/drill are sealed for life, requiring no lubrication. Points requiring
lubrication are:
1. Internal spline drives assembly. Keep this area well lubricated with good grade
non-hardening grease. Insert grease in the hole at the top of spindle pulley spline driver.
Lube twice yearly.
2. A light film of oil applied to the quill and column will reduce wear, prevent rust, and
assure ease of operation.
3. Quill return spring should receive oil (SAE 20) once yearly. Remove cover plate and
apply oil with squirt can or small brush.
4.
IMPORTANT:
The gear box should be oiled with a lubricant such as SAE 68 oil in level.
CHANGE OIL EVERY ONE YEAR.
Change the gear oil:
Tilt the head stock over as shown in Fig 2. Open the oil drain plug to allow the oil to drain
from the opening completely. Then lock the oil drain plug and turn the head to be upright
position. Remove the oil filler plug fill the oil to the gear box until the oil lever reach the
middle of oil fluid lever indicator. Then lock the plug.
5. Apply Lubricant to quill pinion every 90 days.
6.
Note:
use extreme care when performing this operation and keep hands clear of pinch
points. When using paraffin bar, do this only by turning the sheaves by hand. Do not apply
with motor running.