Chery TIGGO, Руководство пользователя, Страница: 103 / 154

Emergency Procedure
102
To replace a lamp bulb, make sure to use a bulb of
same type. Please check the specification of the
lamp bulb before installing it.
Headlamp, front fog lamp bulb:
12V 55W
Turn signal lamp, rear fog lamp, reverse lamp, high
mounted brake lamp bulb:
12V 21W
License plate lamp, brake, clearance, side turn
signal lamp bulb:
12V 5W
Front and rear ceiling lamp bulb:
12V 10W
Headlamp assembly
(high beam, low beam, clearance and turn signal
lamp)
The headlamp assembly shall be removed if any
above bulb needs to be replaced.
1. Open the engine hood.
2. Remove the 3 fixing bolts of headlamp assembly
(the position is shown as the figure)
3. Pull out of headlamp assembly carefully and
disconnect the wire connectors.
High beam, low beam bulb
1. As shown in the figure, press down the
protective cover fixing clip. Remove the protective
cover of low beam.
2. Pull off the lamp seat connector, remove the
fixing clipping ring to take out the bulb; change the
damaged bulb with new one. Clip up the fixing clip
and mount the headlamp cover.
3. Correct the headlamp beams by headlamp
beam tester.
Note:
The halogen bulb must be fixed well in lamp seat.
Front Turn Signal Lamp Bulb
1. Hold the lamp seat and rotate the bulb
anti-clockwise to remove the bulb.
2. Install the new bulb in reverse sequence.
Once after the headlamp bulb has
been replaced, the headlamp shall be
adjusted.