Chemglass CHEMcell CLS-1200-2CH, Руководство по эксплуатации

Страница: 7 / 14

Page 7
•
Autotune is feature built into the temperature controller that automatically calculates the tuning
parameters (i.e. delay times, heating efficiency, heating load, etc.) for any type heater. After the
autotune procedure is complete and the tuning parameters are selected, the controller automatically
loads them into its memory for current and future use.
❖
In most cases if the over temperature protection circuit is active, it must be inactivated
before starting this procedure.
1. Set the equipment up in the exact configuration it will be used. Ensure all connections to the
Temperature Control Module.
2. Turn controller on an enter the desired set point temperature. If the set point isn’t at least
30
°
C above ambient, then skip this procedure and go to the next procedure, ‘Autotuning the
Controller for Very Fine Control’.
Autotuning (refer to Fig. 3)