Chemglass CHEMcell CLS-1200-2CH, Руководство по эксплуатации

Страница: 5 / 14

Page 5
NOTE: An offset temperature value has been added to this controller in a best effort to match the tray size and
RTD sensor used. The offset value compensates for the temperature difference between the tray surface and the
interior of a culture bag. See table below on next page.
1. Once all connections have been verified turn on the Controller via main power switch.
2. If a setpoint temperature value other than 37.0°C is required, then refer to the ‘Quick Reference Guide’
below to change setpoint temperature – the default value is 37.0°C.
3. The Controller will display the as measured temperature from the RTD sensor.
4. The unit will provide power to the Tray Heater which will heat the cell culture bag. Depending on the type
and size culture bags used and the tray size it may take an hour or more to reach the setpoint temperature.
Operating Instructions (refer to Fig. 3)
Figure 2 – Tray attached to Chemcell Base
Figure 3 – Temp. Control Module
Control Key
Down
Arrow
Up
Arrow
Filter Vent Heater,
5Vdc (CLS-1200-FH)
RTD Sensor Pt100
(CLS-1200-RTD)
Tray Heater
(CLS-1200-250 or
CLS-1200-300)
Main Power Switch
(RTD - Pt100 Sensor
adhered to Tray)
RTD
connector
Tray
Heater
Plug