- 07 -
- 08 -
1/1-0.3
1/1-0.7
1/1
1/2
1/2-0.3
1/2-0.7
1/4
…
OF
1/2+0.7
1/2+0.3
1/4+0.7
1/4+0.3
…
1.
Attach the Camera Flash.
Slip the camera flash's mounting foot into the
camera's hotshoe all the way.
2. Secure the Camera Flash.
Rotate the locking screw on the mounting foot until
it locks up.
3. Detach the Camera Flash.
Rotate the locking screw on the mounting foot until
it is loosened.
1. Power Management
Use ON/OFF Power Switch (16) to power the flash unit on or off. Turn off if it will not
be used for an extended period of time. This flash unit has Sleep Function and will
enter into sleep status when there is no operation for a long time. For Sleep Function
setting, see the following instruction.
2. Flash Output
Flash output can be varied from 1/128th power to 1/1 full power in 1/3 stop
increments. To obtain a correct flash exposure, use a hand-held flash meter to
determine the required flash output.
Adjust the power output by rotating Select Dial (14). The following table makes it
easier to see how the stop changes in terms of f/stop when you increase or
decrease the flash output:
Figures displayed when reducing flash output level
→
←
Figures displayed when increasing flash output level
Attaching to a Camera
Using the Flash
1. Do not short circuit.
2. Do not expose to rain or immerse into water. This battery is not water proof.
3. Keep out of reach of children.
4. No over 24 hours' continuous charging.
5. Store in dry, cool, ventilated places.
6. Do not put aside or into fire.
7. Dead batteries should be disposed according to local regulations.
8. If the battery had ceased using for over 3 months, please make a full recharge.
Cautions
Loading and Unloading the Battery
To load the battery, open the battery compartment
cover. Push the Li-ion battery pack into the
compartment according to the arrow indication. A
white knob will lock the battery with a lock sound.
To unload the battery, tap the white knob and the
battery pack will pop out.
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check the battery level
indication on the LCD panel to see the remaining battery level.
Battery Level Indication
M
eaning
Full
Middle
Low
Battery power will be empty and need to be
charged immediately.
Blinking
