Checkpoint Systems, Inc.
– Field Service Installation Document – CKP P/N
10073883
Page 6 of 7
Wiring Procedure
1. Connect
antenna
cable(s)
according to Table on page 2. Plug into ANT1 ANT2
connector, then route cable(s) through the clips for strain relief. Dog-bone excess
antenna cable with provided tie wrap.
Figure 2: Antenna Wiring, Primary Connection (Cable Routing on right)
2. If there are peripherals such as a Key Switch or an external scanner Interlock to
connect, use the following table for the wiring pin-out:
3. Connect AC cord to PSU. Connect PSU to chassis rear
DC Input and slide jack behind the strain relief as
shown in Figure 4 below. Route cabling to avoid
snags. If necessary, use tie wrap to bundle excess.
Figure 3: PSU and Regional AC Cord
Pin #
Interlock/Alarm (J6)
GPIO/12V (J5)
1
INTLK+
GPO RLY
2
GND
GPO RLY
3
INTLK (OPTO)
GPI+
4
INTLK (OPTO)
GND
5
ALARM+
+12V
6
ALARM-
GND
