Installing and Removing a LOM Card
Customer Replaceable Parts
Page 30
d) Loosen the two retaining screws for the lower tray ("
Check Point 21400 VSX Rear Panel
" on page
19
).
e) Pull hard on the extraction handles, and fully remove the tray from the appliance.
2. Find the small coin battery. It is in a black battery slot on the left wall of the system board tray, looking
from the rear.
3. Remove the battery:
a) Move aside the battery retaining clip.
b) Use a small nonconducting device, such as a plastic probe, to move the battery out of the battery
holder.
Caution
- You must place the new battery into the battery holder observing the
correct polarity. The positive terminal of the battery must be facing the wall of the
chassis case.
4. With the positive side facing the wall of the chassis, slide the new battery into the battery holder. Make
sure that the battery is securely installed.
5. Insert the lower tray and turn on the appliance:
a) Move the system board tray into the appliance until it clicks into position.
b) Refasten the two retaining screws for the lower tray.
c) Connect the power cords to the appliance.
d) Press the power switch at the rear of the appliance, to turn on the power to the appliance.
6. Reset the appliance date and time information using the CLI. It is necessary to do this because the
battery keeps the date and time when you shut down the appliance.
Installing and Removing a LOM Card
The Check Point 21400 VSX Lights Out Management card provides out-of-band remote access to the
appliance, even when it is turned off.
The Lights-Out Management card is an optional accessory.
To insert or remove a LOM card
1. Power down the appliance and remove the lower tray:
a) Use the CLI to shut down the appliance.
b) Press the power switch at the rear of the appliance to turn off power to the appliance.
c) Remove the power cords from the appliance.
d) Loosen the two retaining screws for the lower tray ("
Check Point 21400 VSX Rear Panel
" on page
19
).
e) Pull hard on the extraction handles, and fully remove the tray from the appliance.
2. Find the LOM card slot (or the LOM card, if already installed). It is near the middle of the left side of the
system board tray, looking from the rear.
3.
To insert the LOM card:
a) Hold the LOM card at a small angle to align with connector.
b) Insert the LOM card into the connector.
c) Press down on the LOM card until it lies flat.
d) Lock the card into the socket.
4.
To remove the LOM card:
a) Pull the socket locking levers OUT (away from the card edge).
b) Lift the back of the card up and away from system board.
5. Insert the lower tray and turn on the appliance:
