Confirming the Build Numbers
Configuring Check Point 21400 VSX
Page 14
2. Configure the
Per Virtual System State
. This feature is required for the
Virtual System Load Sharing
(VSLS)
.
Enter
y
when prompted to enable this feature.
If you do not intend to use these features, enter
n
.
Note
- You can use the
cpconfig
CLI command to change the VSX clustering
settings.
Completing the Configuration
Complete the last steps of the First Time Wizard. The appliance reboots and is configured according to your
settings. To use the VSX appliance, you must configure and install a security policy according to the
VSX
NGX R67 Administration Guide
(
http://supportcontent.checkpoint.com/documentation_download?ID=10165
).
To complete the First Time Wizard and reboot the appliance:
1. You can add a license.
2. Enter and confirm a SIC activation key. This key establishes SIC trust between the gateway and the
management server.
3. If VSX clustering features are enabled, you can enable ClusterXL for
Active/Standby Bridge Mode
.
4. Enter
y
to reboot the appliance.
Confirming the Build Numbers
Confirm that the system has the most recent build numbers. Run these CLI commands to display the build
number for these products.
Product
Command
VSX Appliance Build
SecurePlatform
VSX
ver
This is Check Point SecurePlatform Pro VSX
NGX R67.10 Build 012.
Dynamic Routing
gated_ver
650000001
VSX
fw ver -k
This is Check Point VPN-1 VSX NGX R67.10 -
build 006.
kernel: NGX R67.10 - Build 006.
Performance Pack
sim ver -k
This is Check Point Performance Pack
version: NGX R67.10 - build 003.
Kernel version: NGX R67.10 - Build 003.
