CHD VS-MIDI, Руководство по установке

Страница: 6 / 16

VS-MIDI
MIDI Interface for Vermona Synthesizer
Model 8-434 ver. 1.0
Copyright © 2009 CHD Elektroservis
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
6
The MIDI connectors installation procedure is then as follows:
a) Flip the cover over and return it to its original closed position on top of the instrument.
b) Drill two holes with diameter 16 mm and four holes with diameter 3,2 mm to left side of rear
panel of the instrument as shown on pic. 2.2-3. Work carefully so as to not drill the parts and
components inside the instrument (pic. 2.2-4).
Pic. 2.2-3 Pic. 2.2-4
160
22,5
32
30
c) Clean the edge of the holes with small rasp. Also clean the holes from the inside after the
turning over the front cover.
d) Clean all metal sawdust and raspings from the inside of the instruments , they can cause
short circuits or serious electrical damage if left in the instrument. Please clean the instrument
carefully!
e) Get flat connectors of MIDI cables through the holes in rear panel into the instrument (pic. 2.2-
5). Both cables are the same and they can be exchanged.
f) Insert the DIN connectors into hole in rear panel (pic. 2.2-6) and fix the connectors to the panel
using screws, washers and nuts (pic. 2.2-7).
Pic. 2.2-5 Pic. 2.2-6