CHD Elektroservis JU6-KBD, Руководство по установке

Страница: 9 / 12

JU6-KBD
MIDI Interface for Juno-6 Keyboard
Model 8-429 ver. 1.0
Copyright © 2010 CHD Elektroservis.
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
9
d) Cut the blue wire from the pin Nr. 37 (CLK) of connector “36~39” on the instrument’s main
board (pic. 2.3-5). Remove the insulation (approx 5 mm) from both ends of the blue wire and tin both
ends of the wire (pic. 2.3-6).
e) Place a shrink-wrap insulation tubes (parts of delivery) on both blue wires (Nr.1 and Nr. 2) of
interface’s bunched cables.
f) Solder the end of the wire from pin Nr. 37 of the connector “36~39” on the instrument’s main
board to wire Nr. 2 (CLK-OUT) of interface’s bunched cables (pic. 2.3-7).
g) Solder the other end of cut blue wire to wire Nr. 1 (CLK-IN) of interface’s bunched cables (pic.
2.3-7).
Pic. 2.3-5 Pic. 2.3-6
Pic. 2.3-7 Pic. 2.3-8
h) Isolate the soldered connections with the insulation tubes and heat them until they shrink
tightly to the wire. The tubes can be heated with a hot-flue pistol, for example (pic. 2.3-8). Be very
careful so that no cables or components are damaged during this operation!