CHCNAV CHC E91, Руководство пользователя

Страница: 24 / 66

Base Station Setup and Operation
24
5. Level and plumb the receiver over the known (control) point.
6. Measure the height of the base station GNSS antenna by measuring the slant
height from the known (control) point to the auxiliary H.I. tool.
Note – After entered the vertical height from the known (control) point to the bottom
of receiver that you calculated by adding the height of the extension pole to the height
from the known (control) point to the end of auxiliary H.I. tool, LandStar 7 will calculate
the height to the Antenna Phase Center (APC) automatically.
7. If required, connect the receiver to an external 12 V power supply.
For external radio part (take the CHC DL6 Datalink for example):
8. Connect the Datalink Antenna to the 3 meter Cable for Datalink Antenna.
9. Connect 3 meter Cable for Datalink Antenna to Datalink Antenna Mounting
Pole.
10. Screw the Datalink Antenna Mounting Pole onto the tribrach adapter.
11. Mount the tribrach onto the tripod.
12. Insert the tribrach adaptor into the tribrach.
13. Set up the Datalink Antenna nearby the base receiver.
14. Fix the DL6 Datalink onto the tripod.
15. Place the car battery at an appropriate location.
For connection between the receiver part and external radio part:
16. Connect Datalink Antenna to the Datalink Antenna Slot of DL6 Datalink via 3
meter Cable for Datalink Antenna.
17. Connect the base receiver with DL6 Datalink via GPS to Datalink Cable.
18. Connect the car battery with DL6 Datalink via Datalink External Power Cable.
CAUTION – The Datalink Antenna must be connected to the Datalink before
the Datalink is powered on; otherwise, the Datalink can be damaged.