Chauvin Arnoux Metrix MTX 3292B, Руководство пользователя

Страница: 52 / 55

52
13. APPENDIX
Default configuration 13.1.
In
User mode, the device restarts in the user's personal configuration (General and Measurement menus) and the function
selected when switched off, but coupling in Volt function (AC+DC).
In
Basic mode, the default, the multimeter starts up in its elementary configuration (default values) and in the Volt function
(AC+DC).
General Language: EN/language
Beep: yes
Sleep: yes
Lighting: ECO Communication: IR
IR baud: 38400 Configuration: basic
Energy: Ni-MH
Storage battery capacity: 2,500mAh
Communication protocol: MODBUS
Measurement Filter: NO Impedance: 10/20M
dBm REF: 600

W REF: 50

Func. CLAMP,
Func. MATH
Function: V Unit: A
Ratio: 1A/AV
Function:
V Unit: none
Coef. A: 1 Coef. B: 0
Func. MEM Recording interval: 1s
Nb. of records 3292B: 10000 Nb. Of records. 3293B: 30000
Main functions V, A: AUTO, AC+DC Hz: 10V range

, Capacity: AUTO ° C: ° C, Pt 100
* FR, DE, IT, ES depending on the embedded software loaded and the user's selection.
Restart configuration assumes no leads connected. If they are connected, they will be taken into account in the selection of
the function
Instructions before recharging the storage batteries 13.2.
Before recharging, check that the device is equipped with all 4 storage batteries.
It is not necessary to withdraw them to recharge them. If "Ni-MH" is selected in the Type of Energy menu (see paragraph),
then charging is enabled.
An attempt to charge with primary batteries in the device may damage the device.
For safety reasons, the charging of the storage batteries is enabled only between:0°C and 35°C.
Note: an elevation of the internal temperature by a current measurement may possibly trip the thermal safety.
In order to keep the storage batteries in good condition, use the multimeter until the min. level is reached before recharging.
Then connect the plug of the power supply unit USB to the specific jack.
Connect the power supply unit USB to mains.
The symbol opposite on the display unit is used to monitor the course of the charging with a % of charge:
- battery charged

green symbol and 100%
- battery discharged

orange symbol, indicating charging recommended
- battery level at limit

red symbol and xx%
- battery level too low

blinking red symbol and % together with audible beep
The storage batteries are fully charged when the symbol is stabilized with 4 segments (each fixed plateau is acquired), after
approximately 6 h.
The multimeters are delivered with 2500mAh Ni-MH storage batteries.
These used storage batteries must be turned over to a recycling company or a company processing hazardous materials.
Never throw these storage batteries away with other solid waste.
For more information, contact your Manumesure agency.
Once the storage batteries are fully charged, the device stops automatically.
When the multimeter is delivered, it may happen that the storage batteries are discharged and require full recharging.